Blizzard-lighting EM-Pulse LED Strobe Fixture Manual do Utilizador descarregar pdf (Página 9)

Page 9

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3 pin connector side of the

DMX cable to the output (female) 3 pin connector of

the rst xture.

2. Connect the end of the cable coming from

the rst xture which will have a (female) 3 pin

connector to the input connector of the next xture

consisting of a (male) 3 pin connector. Then,

proceed to connect from the output as stated above

to the input of the following xture and so on.

A quick note:

Often, the setup for

Master-Slave and

Standalone operation

requires that the

rst xture in the

chain be initialized

for this purpose via

either settings in

the control panel

or DIP-switches.

Secondarily, the

xtures that follow

may also require a

slave setting.

Check the “Operating Adjustments” section in this manual for

complete instructions for this type of setup and conguration.

Mounting & Rigging

This xture may be mounted in any SAFE position provided there is

enough room for ventilation.

It is important never to obstruct the fan or vents pathway. Mount the

xture using a suitable “C” or “O” type clamp. The clamp should be

rated to hold at least 10x the xture’s weight to ensure structural

stability. Do not mount to surfaces with unknown strength, and ensure

properly “rated” rigging is used when mounting xutres overhead.

Adjust the angle of the xture by loosening both knobs and tilting the

xture. After nding the desired position, retighten both knobs.

• When selecting installation location, take into consideration lamp

replacement access (if applicable) and routine maintenance.

• Safety cables MUST ALWAYS be used.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sem comentários

Blizzard-lighting EM-Pulse LED Strobe Fixture Manual do Utilizador Página 9